0 Replies Latest reply on Jun 4, 2008 10:11 PM by Wayne Tiffany

    Bolt connector recognizing Hole Series

    Wayne Tiffany
      What I think I am seeing is that while SW2008 will put a Hole Series into two parts in an assy that are 2 configs of the same part, it would appear that COSMOSWorks will not recognize that HS. I tried the same thing with two distinct parts in the assy and CW asked if I wanted to put the same bolt connector in all the HS holes, and it did it just fine. Has anyone else seen this?

      WT