until this morning I could decide which plane I wanted to
select be hovering over it in the tree. Now I select 'insert
sketch' and go to the tree to select the plane I want to skech on
but they don't preview.
For example if I have a part I am building,without the
standard plans displayed, and I want to insert a sketch on the
right or front plane but I can't remenber which one, I would click
insert sketch then run the mouse pointer over the three standard
planes and what used to happen is the plane would highlight, I
think red border, then I'd know which one to chose.
It is not just parts but assemblies too when I am asked to select a
plane for some operation.
And a few more questions just to understand:
Is View>Planes toggled on or off?
Are the individual planes set to hide or show?