Hello all,

I am having an issue trying to create stent geometry. I have created a series of planar surfaces that model the geometry I am interested in. However, when I loft more than one segment, the shape becomes totally irregular.

I have attached a picture of a section of the model, but I created it by lofting 2 segments together over and over. While it does give the right shape, I need to create the geometry as a single body. I did try using sweep, but it does not recognize any of my entities as profiles.

Also, I tried to create a curve that follows the plane surface edges, but it does not guide the solid correctly.

I was wondering if anyone could assist me in creating the geometry through the curves, or assist me in creating a single solid from the series of lofts?


Thank you in advance,

Arjun Menon

CardioPulmonary Rehabilitation Lab
Marquette University/Medical College of Wisconsin