Tom Hall

Custom Properties and editing

Discussion created by Tom Hall on May 15, 2008
Latest reply on May 16, 2008 by Erik Balle
I have opened Toolbox, created new properties under the "Properties" tab while configuring the Toolbox and have applied the new porperties to a new standard of components.

When I create a new part by clicking on a Tooldbox component and select "Create Part..." I can enter data into these new custom parameters.

But after I select the ok to accept the new part I can not find this data anywhere in the new part. Does any one know where to look so that it may be edited again?

Thank you,
-Tom

SW 2008

Outcomes