AnsweredAssumed Answered

live preview the problem?

Question asked by John Kreutzberger on May 13, 2008
Latest reply on May 14, 2008 by John Kreutzberger
I have posted a few cranky questions related to the new interface and in general have had my questions answered so that I can work semi-productively. Therefore I'll try to keep the tone of my current question positive and hope for the best.

I have been having a problem when editing a sketch to correct either an error of mine or a change in direction. The feature that I am trying to change still shows up and gets in my way when trying to make a change. What I would like to see is the old geometry that was there before I introduced the new feature. However-the only way I can seem to do this is to completely delete the feature and start over. I have looked for a setting that could be turned off, but with no success.

I hope I have explained this clearly and that there is a solution. Thanks.

2008, sp2