AnsweredAssumed Answered

Solidworks 2008 taking 3 minutes to close

Question asked by Andy Sanders on May 8, 2008
Latest reply on May 13, 2008 by Andy Sanders
I can't figure this one out.

For some reason, I believe it was after an upgrade to 3.0 to 3.1 of SW2008, I began to notice super long SW shutdown times. As long as 3-4 minutes.

In the past, my SW shutdowns have always been fine, maybe 10-15 sec.
I can't put my finger on when it may have started, but I think it was after the 3-3.1 upgrade (32bit XP).

Has anywone else experienced this? I really don't want to go through the unintstall/reinstall/service pack merry go round just for this issue, as everything else is working fine.

Outcomes