0 Replies Latest reply on Apr 22, 2008 1:24 PM by Mike Radoiu

    tap hole does not show dashed line for bottom

    Mike Radoiu
      I did not use very often SolidWorks 2008, until SP 3.0 was released. With SW 2008, SP 3.1 I encountered lots of problems: in assemblies, in parts modeling, drawings.
      Before sp 3.0 my drwdot template with defined layers worked fine.
      After S.P. 3.0 every thing is gray or black. Now I found out that tap holes are looking the same way like clearance hole (no dashed line for bottom of tap hole).
      Is anyone having similar problems????!!!!