AnsweredAssumed Answered

How to represent bridged connections (Built In Busbars)

Question asked by Kassym Dorsel on Jun 6, 2016
Latest reply on Jun 24, 2016 by Kassym Dorsel

Hi,

 

I've trying to figure out the best way to represent connecting Motor Drives via add on bridge modules. For every drive a separate bridge module is required, thus two symbols are needed for keeping track of components.

 

Below is a picture of what it would look like once assembled:

Screenshot_4.png

 

And up to this point this is what I have:

Screenshot_5.png

There would be wires coming into the left AX5901 since it is the first one and there would need to be a connection between the right AX5911 and the next AX5911 on the next page. And lastly a connection where the red arrow is.

 

I could always just uses wires to show the connection, and add a note, but I don't like it.

 

Thanks !

Outcomes