3 Replies Latest reply on Jun 6, 2016 4:11 PM by Brian Goss

    Assembly Features/ Mirroring Components

    Brian Goss

      Is there anyway to get assembly features to show up in part drawings? I've got two parts with identical cuts at the same respective place on each part. One component is just a mirror version of the other so I decided to make the cuts in the assembly or else the cut would be near the bottom of one part and near the top of the other. The only problem is when I go to make the part drawing obviously the assembly cuts don't show up. Is there a way to either just make a drawing from the part at the assembly level or does anyone have any other solutions? If not I could always make a right and a left part and bring them in seperately but it would be nice if it was one part file.