AnsweredAssumed Answered

Problem with the "list selected" tool

Question asked by 1-BZDFRG on Apr 9, 2008
Latest reply on Jun 18, 2008 by 1-BZDFRG
I noticed the following problem with the list selected tool in cosmos 2007 SP 4.0.
I selected a rack tooth root radius with a lot of elements across the face. I was looking for a node in a particular location and I noticed that the nodes listed as on the face only extended about halfway across the face in the X direction. The rest of the nodes were not there.

What gives? I've attached a screen shot showing the node in the most negative x coordinate highlighted. However, as the picture will show, the node is in the middle of the selected face, relative to the x axis.

Attachments

Outcomes