2 Replies Latest reply on Nov 11, 2006 6:25 AM by

Heres a challenge

Guest Nov 11, 2006 6:25 AM

Not too sure if this is a surfaces prob or other. Need to some how get a flat pattern of this part for laser cutting. Can I project or wrap these faces to get the true flat shape? Any ideas?

Heres a challenge

Guest Nov 11, 2006 6:25 AM (in response to Guest )

Check this attachment. Maybe I have misunderstood some cuttings, but as far as I can see it should be normal cut except the one that creates the sharp edge.
Like Show 0 Likes(0)

Actions
Heres a challenge

Guest Nov 11, 2006 6:25 AM (in response to Guest )

If the part was created using Base Flange, then Solidworks should give you the flat-layout
Like Show 0 Likes(0)

Actions

Go to original post