Paul Labelle

Graphics Card Issues

Discussion created by Paul Labelle on Apr 2, 2008
Latest reply on Apr 24, 2008 by Adam Sandler
I have had this happen several times over the last month, it never happened until I upgraded to SW2008 from SW2007.
When exiting from editing a model within an assembly, or when trying to MMB rotate the model, my systrem reboots.
Once rebooted, I get a Windows message that says "your system has recovered from a serious problem" try these steps to fix.
The first step was to install the latest drivers fr the video card. The video drivers were updated at the upgrade.

The second step was to turn off "hardware accelleration" this caused other issues!

Any suggestions?
Windows XP
2Gb Ram
SW2008 SP3.1