AnsweredAssumed Answered

Bending a round plate

Question asked by Robert Woods on Mar 27, 2008
Latest reply on Aug 27, 2008 by Wayne Tiffany
I looked through a lot of the questions already asked, and didn't see anything that was similar to what I am trying to do.
I have a piece of 10 ga. hot rolled that is 4" dia. I am needing to bend up 90 degrees in 4 place so the bent legs go up the side of a 2 1/2 square tube.
When I try the "Sketched Bend", I get a message saying it's an invalid sketch. I don't get any of the other bending tools to even give me an error.
So, how would I go about doing this?
I've only been using SW for about 5 months, so I still have LOTS to learn.
Thanks so much for your help and suggestions.

Outcomes