0 Replies Latest reply on Mar 14, 2008 2:14 PM by Martin Cox

    Strange Dimension Corruption in SW 2007 sp5

    Martin Cox
      I am experiencing a strange corruption of dimensions in SW 2007 sp5 since I installed SW2008 sp3.
      I have experienced 3 cases were baseline dimensions referenced to a tangent edge have become incorrect after saving the drawing.
      In one case dimensions referenced to an inside tangent edge of a tube showed the dimension figure to the outside of the tube.
      In another a baseline dimension to two points from a tangent edge flipped the 2 dimension values corrupting both dimension values (see JPEG)
      Graphics card is a Quadro FX 1400 Driver is approved 6.14.10.9136

      Tech support are asking me dumb questions
      Has anyone else seen anything like this?