AnsweredAssumed Answered

Line Segments

Question asked by Paul Labelle on Mar 3, 2008
Latest reply on Mar 3, 2008 by Paul Labelle
I have upgraded from SW2007 to SW2008 SP3. In a new sketch in a part, when I try to draw a line, the command exits after 1 segment, I then have to go and pick the line command again to continue drawing. As an aside, the other day while trying to dimension a sketch, every time I placed a sketch dimension I had to repick the dim command to add another.

This was not the case in 2007. I have gone through the options and cannot seem to fix this.

Any suggestions?

Outcomes