This content has been marked as final. Show 2 replies
There are two different sketch flyouts available in the flyouts section of the customize dialog. The first one is in the third row, second position and is a type of flyout where its contents are populated based on the definition of the stand alone sketch toolbar. The second one is in the fourth row, second from the end. This one is a hard coded flyout with just 2D and 3D sketch on it. The first one should work fine in drawings, but the second one will always be grayed out because the 2D and 3D sketch buttons are not applicable in drawings.
I hope this helps,
Oh, look at that! Great.