Ok, so I upgraded to 2008 SP 2.1 (as it turns out I did this about 3 hours before SP 3 came out) I was on 2007...

I'm working on a sectioned view of an assembly and did some fairly nice renderings in 2007. When I brought it into 2008 it seemed to be fine (we won't discuss the Toolbox bolts...)

Now, when I render in 2008 I'm getting transparency on some parts that shouldn't be there. Not total transparency, but some - enough to see other parts behind the part in front. Unless I'm missing something (which is highly probable) this should not be happening.

Any ideas??

Thanks.

Todd B.