2 Replies Latest reply on Feb 26, 2008 6:35 PM by Josh Kersey

    Analysis of a Bowl/Cylinder

    Piyush Sharma
      Hi
      Am doing an analysis on a Bowl part where I am providing immovable restraints at the Thread region and Pressure in the regions as required. The problem which am facing is Cosmosworks is showing high stresses at the interface/edge of restraint and free surface which is not true.
      The part has a thread relief and it is at the centre of this thread relief where high stresses are suppose to generate. But in my case, its showing high stresses at the edge between the thread and thread relief. Based on the lab experiemnts also this result is weird.

      So do you guys know any good way to simulate threads and to avoid showing of high stresses at the restraint thread and the free surface.

      Any good advice?