I basically a beginner with Solid works.
I can't understand that sometimes when I sketch say a rectangle, and then if want to add another sketch to it, say a line on top of it, it does not allow me to start the line from anywhere on the edge of the rectangle but only from the midpoint or the end vertices of the edge. Can't figure out why?????
I can't understand that sometimes when I sketch say a rectangle, and then if want to add another sketch to it, say a line on top of it, it does not allow me to start the line from anywhere on the edge of the rectangle but only from the midpoint or the end vertices of the edge. Can't figure out why?????
Thanks Mark....it worked.
options->sketches->relation/snaps.........turned it off.