Bill Le

Can not open "Help" on Solidworks

Discussion created by Bill Le on Feb 6, 2008
Latest reply on Feb 6, 2008 by John Burrill
Every time I open help, it comes with the message "Could not open hgelp file. Please check that your system has sufficient memory". It has happened since 2007 version and carry over after upgrade to 2008. I did the different way by completly remove all version from my computer then fresh install 2008 and update to latest SP but could not resolve.

Dose anyone else has this issue? Do we have any solution? Could you please share.

Thank you.
Bill

Outcomes