Paolo Marconato

Video cards or bad installation?

Discussion created by Paolo Marconato on Feb 4, 2008
Latest reply on Feb 5, 2008 by Andy Sanders
I installed SW 8.0 in my notebook. minimum requirements are achieved, only video card is low level. Program start ok, but if I try to extrude a simple sketch (a circle) the following fault appears: "in the sketch zero dimensions elements are present". is it possible it depend on the graphic card or is it a wrong installation or whatever?

n.b. also if I open an exinsting file (for example a tutorial file) it's in a errore state

thanks in advance

Paolo

Outcomes