3 Replies Latest reply on May 26, 2016 3:53 PM by John Stoltzfus

    Question about BOM to part/assembly property linking, how can I tell if it is linking to parts/assemblies as a whole, or linking to configuration specific properties?

    Steven Mills

      Is there a way to tell if a BOM is linking to the part properties as a whole or to configuration specific properties while in a drawing? Other than by making a change to the BOM and then opening the part to check that it changed there as well.

       

      Being able to tell or set that from a drawing level would be a big help when I just want to put all the parts into an assembly, then change the properties at the drawing level across multiple parts.

       

      I am using SW2016.