AnsweredAssumed Answered

Toolbox message when saving assembly

Question asked by James Smith on Jan 8, 2008
Latest reply on Jan 8, 2008 by Dale Dunn


Im using SW2008 sp1.1

I have an assembly into which i insert bolt or such like from the toolbox. I dont use the toolbox very often, in fact i havent used it since upgradnig to 2008.

However, since i have now usd it, when i save the assembly SW tells me the particular bolt i have inserted will be converted when saved.

Also when i open up the assembly i get the message "The following documents will be converted when saved: Socket head cap scew.sldprt"

Surely, i am using the 2008 toolbox (i told it to replace when upgrading) so why is it showing this message ?

Anybody got any ideas ??!