4 Replies Latest reply on May 31, 2016 10:40 AM by Tim Lewis

    Specifying a default tolerance in a hole table

    Tim Lewis

      Over a year ago, Jason Ross posted this question and didn't receive any response.  I'm running into the same issues and wondering if I can get a better response.

       

      To summarize, there's two issues here:

      1. Is there a way to specify the default tolerance (e.g. basic) on the X/Y dimensions in a hole table?
      2. Is there a way to add a geometric position tolerance to the size specification in the hole table?

      To be clear, here is what I want to do:

      Screenshot_3.jpg

      The only way I know of to do this is to manually specify basic tolerances for the X/Y dimensions and manually specifying and placing the position tolerance (as well as manually adjusting the height of the cells to accommodate the tolerance).  Anytime anything changes that affects any of the information in the hole table, most if not all of that needs to be redone.