1 Reply Latest reply on Jan 6, 2008 3:53 PM by Anna Wood

    Has this functionality been updated with 2008?

    W Jones

      This is a previous forum post. This functionality would be extremely useful when dimensioning bolt cirlces. This would allow the updating of the bolt circle diameter and hole callouts without having two seperate dimenions/notes.

        • Has this functionality been updated with 2008?
          Anna Wood
          No, this has not been added to SW2008......

          If it is important to you make sure to put in an Enhancement Request with SolidWorks. The more people that log Enhancement Requests the more likely that functionality will be added to SolidWorks.