7 Replies Latest reply on May 23, 2016 8:40 PM by Paul Salvador

    Wrap Feature Across Tangent Faces Fails - SW2014

    Daen Hendrickson

      I am using SW2014 - SP5.

       

      I have a wrap feature that is causing problems and I am looking for suggestions.

       

      I have attached a SW2014 format example file. The sketch to be wrapped transitions across two surfaces - a circular and planer surface that are tangent. The preview of the resulting wrap feature shows results on both surfaces, but there is a discontinuity and the feature will not build correctly.

       

      Suggestions?

       

      Thanks

       

      Daen