AnsweredAssumed Answered

initiating shapes circle,rectangle.. starting point weird behavior

Question asked by Peter Thannhauser on May 22, 2016
Latest reply on May 23, 2016 by Glenn Schroeder

I'm noticing this kind of irritating behavior when I initiate a shape like a circle or rectangle... anything that requires the typical 1,2,3 starting point. I'll use the circle screen grab as example. If I start it somewhere off in space (blue circle), it extends out just like its supposed to. But if I start it on a defined point, in this case at the end of the line, it kind of jumps the gun with the dimensional input box (0 presently) & kind of locks in that mode without letting me finish extending the circle. Actually I find this dimensional input box a bit cumbersome anyway. I like to go back & dimension things after sketching. Is there a way to turn this off & maybe that will solve both issues simultaneously? (SW-2016-V3)

 

5-22-2016 0003.jpg

Outcomes