0 Replies Latest reply on May 18, 2016 2:17 PM by Nicole Hernández

    Virtual wall

    Nicole Hernández

      Hello, 

       

      I am new to using virtual wall and I am having some trouble with it.  As seen below I have created a virtual wall that is at an angle relative to the plate.The wall type I chose was rigid with a coefficient of friction of 1.  What I am try to achieve is for the plate to be able to translate from the plates current position to the virtual wall and also able to slide freely on the virtual wall.

       

      Any thoughts would be much appreciated.

       

      Thanks.