AnsweredAssumed Answered

the leader in geometric tolerance does not extend to the edge in a detail view

Question asked by Martha Miller on May 16, 2016
Latest reply on May 27, 2016 by Martha Miller

Using SW 2016 SP2.0

I'm trying to attach a geometric tolerance to and edge in a detail view using a leader, pulling it up so it makes an extension line in the view.  The leader truncates and is about an inch away from the detail view.  I have tried enlarging the detail view to encompass the entire part, adding the geometric tolerance and then re-sizing the detail view to be smaller, but that did not fix the problem.

See attached .png file for illustration.

Thanks

Attachments

Outcomes