AnsweredAssumed Answered

fillet between two non intersecting bodies

Question asked by Brian Hoerner on Dec 4, 2007
Latest reply on Dec 13, 2007 by Brian Hoerner
In a couple other programs I have used in the past, I was able to create a blended "fillet" between to different bodies, so imagine two spheres they are both 3"Ø placed about 6 inches apart, then select the fillet command, then the two spheres, you end up with a "dumbell" type of result. Of course there were some options that allowed for stretching etc, and there was of course a minimum radius you could use,

I imagine at this point there is no way to do this type of fillet?

Outcomes