You should be able to select the text and drag where you want. Any specific reason you want to move them?
If you edit the sketch of the section line, you should be able to move it closer to the position you want. Is that what you're after?
If you want to just drag the letters, select them and move them.
Thank you all, for your prompt response. But its not about section view line text.my concern is about auxiliary view. while we take auxiliary view a line with text come up. i want to move text that.
Can you do a screenshot of what you're trying to do? It might help us to understand...
Is the text circled in red below what you want to move? If yes, you should also be able to grab it and drag it where you want.
So, this is an ISO auxillary view ( B) that I have that was taken from a section view (Section A-A). I can grab the B and it's arrow and move it anywhere. You can also see, sort of, that the auxillary view has been moved to another location on the drawing sheet.
Is moving B and it's arrow what you're looking to do?
Click on text and drag it by selecting point shown after selection. Refer below image
Retrieving data ...