2 Replies Latest reply on May 3, 2016 1:19 PM by Timothy Taby

    Changing sketch text via design table

    Timothy Taby

      I have a series of parts that I created via a design table.  They are rotary discs starting in size from 6" diameter up to 24" in diameter in 1" increments.  These are molded parts and I need to put the size by the edge to denote what size it is, so I am using the sketch text and raising the text 0.01" from the surface.  Is there a way to get the sketch as a variable so I can add it to the design table and not have to create each one individually?