I inserted a BOM in an assembly and I can not get it to show fractions only. I changed the units in options in the parts, assembly, and templates levels, but to no avail...it still shows a mixture of fractions and decimals.
You might check your models and see if that box is checked. I say that because my Part template is set to display decimals and my Drawing templates are all set to display fractions, and I've had cases where notes in the drawing that are linked to cut list properties would display linked values as decimals in the Drawing until I switched Units in the Part file to fractions.
In your Drawing options, click where the arrow is pointing to and check the circled box.
Thanks for your response Glenn, but I had tried that before and I just tried it now again to make sure. I wonder if using the detailed cutlist in your BOM in the assembly only pulls the information without any formatting from your properties. The interesting thing is I can get it to work if I create a drawing from the assembly and insert the BOM, but not within the assembly.
I finally got this to work at the part level. I had to rebuild and save after making the unit changes for it to reflect in the BOM...thanks!
Retrieving data ...