Hi,
I've been tasked with designing a propane distribution manifold with a CGA-510 (or POL) inlet. I have been able to find the correct thread (.885" - 14 NGO - LH - INT) but have not been able to locate any information for the taper that the male nipple seats against. Would appreciate any help with identifying this.
Have you looked into the CGA standards for the dimensions? There are CGA standards that detail how each part is machined.
I know this post is older, but let me know if you were able to find anything. I also do a lot of gas manifold designs, so I'm interested to know if anyone else has these fittings in SW or STEP.