Currently on SW2016 SP2. Just ran into this today. Patterning some fasteners to a driving pattern, I want to skip an instance of the fasteners. When I go to select the instances to skip, there are no selection points. Happen to anyone else?
Currently on SW2016 SP2. Just ran into this today. Patterning some fasteners to a driving pattern, I want to skip an instance of the fasteners. When I go to select the instances to skip, there are no selection points. Happen to anyone else?
Well, I hate when I post a question and then find the answer myself. Apparently, there were still some lightweight parts in the assembly. Once they were fully resolved the selection points magically appeared again.