AnsweredAssumed Answered

Render to File Crash?

Question asked by Rich Osterreicher on Nov 28, 2007
Latest reply on Nov 29, 2007 by Rich Osterreicher

Like • Show 0 Likes0
Comment • 2

The part's i'm working with are '08 created.. With '08 materials.. in '08 scenes..
I can render the screen no problem..
Whenever i try to render to file. It crashes..
See pic for the error message..

Anyone see this before??

Attachments

Render Error.JPG59.2 KB

No one else has this question

Outcomes

2 Replies

1-9C36HC Nov 29, 2007 11:16 AM
Mark Correct
Correct Answer
Rich,

Can you give a little more details? I assume you're rendering a PW file. What resolution, what format etc?

Have you tried it on another machine? Does it just crash on a specific part or assembly?
Like • Show 0 Likes0
Actions
- Rich Osterreicher @ 1-9C36HC on Nov 29, 2007 12:10 PM
  Mark Correct
  Correct Answer
  Hi Mark,
  Here's what's been goin on..
  I tried restarting pc.. a few times.. same prob..
  I went to make an rx thingy... But it all froze and i had to cntrl alt del...
  I rebooted pc.. tried again and it works..
  Been working fine now since then..
  It was doing with any parts or assemblies..
  '08 created ones, or old ones, etc..
  Materials or scenes didn't matter.. Any of them did it.
  It would render the window just fine..
  It only crashed when i tried to render to JPG.
  I had it set to hig res, 640x480.
  
  But, it's working fine now since the rx freeze..
  I'm guessing it was just some weird fluke thing..
  It's working fine now..
  
  Thanks..
  Like • Show 0 Likes0
  Actions

Render to File Crash?

Attachments

Outcomes

Related Content

Recommended Content