2 Replies Latest reply on Apr 18, 2016 8:39 AM by Tateos Tvapanyan

    Enlarge a rectangle by both sides

    Mbc Mbc

      Hello, I 'have a SolidWorks project with a 42,5mm by x mm rectangle. But the side that is 42,5 mm I want to convert it into a 51 mm side. But the problem resides on the fact that when I set the new measure SolidWorks make the rectangle bigger only from one side, and I want to make it from both sides because the same rectangle is centered in antoher rectangle. In this case, I have to enlarge 8.5mm the width, so I want that for each side of the rectangle solidworks enlarges 4,25mm so the rectangle is still centered on the other rectangle

      I atach an impant.

       

      Thanks