0 Replies Latest reply on Apr 10, 2016 10:09 AM by Steve Harman

    OK so I know people are making sinks with a large radius - HOW!!!

    Steve Harman

      I am trying to make a simple sink bowl with a 3/4" radius on the four bottom corners as well as the four vertical corners.I know people are using solidworks in their manufacturing to do this. Typically in the real world the sink would be made with the bottom and two opposite sides formed out of one piece and two ends welded on the remaining sides to make the complete sink. I cannot figure out how to accomplish this.

       

      Any help would be greatly appreciated.

      Thanks

      Steve