AnsweredAssumed Answered

SW 2016, Hole wizard dims. Double click for dimensioning?

Question asked by Paul Risley on Apr 8, 2016
Latest reply on Apr 11, 2016 by Paul Risley

Has anyone else seen this? When you are laying out hole positions it used to hightlight the dims. Now in 2016 it doesn't which creates an extra step when putting in holes. For one hole not bad, but I had a part that had roughly 70 holes on uncommon lines so I had to dimension each one and this was time consuming. If there is a setting I need to change to get rid of this extra step I would appreciate it.

 

Thanks.

Outcomes