The toolbox parts like Bolt and other components when dragged and dropped and used it behaves abnormally .
For reference attached some images.
Something similar happened to me a while back.
What had happened to me was I had taken a model of a bolt and changed the units inside the model from metric to inch.
Since the table that drives the size of the bolt did not have units assigned to the numbers, the model actually scaled (example, a 2mm dimension suddenly became 2"). This caused a few of the internal sketches to go bad as well.
The reason that I had changed the units was that I wanted the weight to show in pounds rather than grams. So ultimately, I had to ONLY change the mass units to pounds but leave the rest in metric.
Did something similar happen to you?
No not like that ,but when i drag the component and when i try to change the configuration the sketch goes bad and to some other shape
I stopped using Toolbox hardware years ago. Too buggy. All to often, I'd open a model and a 1/4" nut would be 2" across.
Way too unstable.
Make separate models of each nut and bolt size as you need them.
Retrieving data ...