Coloring is incomplete. I have created parts of a surface using split line and want to color , but the color when applied is incomplete - a bit like zebra stripes, but not. Any ideas?
Coloring is incomplete. I have created parts of a surface using split line and want to color , but the color when applied is incomplete - a bit like zebra stripes, but not. Any ideas?
Since there are no visuals for us to see (pictures) or (Model) -
I will say it is a Graphic Card issue
I found the solution. I had knitted a solid surface to a surfaced part - when I unknitted the two the coloring worked. The split line boundaries are on the solid part, so why this should happen I don't know.
Thanks for responses.
I was just going to say that. Sometimes two surfaces are laid upon each other and you'll see them both.
Steve C
The two surfaces were adjacent not overlaid. Thanks for your response.
Can you post a picture or even your part?