am wanting to wrap these graduations on a cylinder but SW will not wrap disconnected entities. i also will need to wrap text starting at 120 to 180 in increments of 10. any easier way to do this?
the wrap feature does support disjointed profiles - but it does require CLOSED profiles
you will need to add some width to your lines to be able to wrap them. and text works well too (with some caveats based on font)
right, meant open profiles. i ended up extruding an engraved profile and used pattern.
for the text, is there a way to specify the spacing? so it lines up with the graduations or will i have to do each number individually?
Retrieving data ...