Hello All,
Perhaps someone can help me, im just starting with SW2016 and was bussy with te tutorial scheetmetal.
Now i want to move my arrowheads to the endpoints of the bendline but the settings are so it will automaticly snap to the midpoint were can i change the settings
When i try to move it, the arrowhead snaps back to the centerpoint of the bendline
Thanks
marc
Hello Marc,
Have a look at this video (just 01:13 min) and I hope this may help you.
Note: I dragged the leader while holding it at the arrow tip and moved the snap point along the line where I have to place it.
(Please do mark this answer as correct if it helps you)
Cheers,