0 Replies Latest reply on Mar 29, 2016 9:18 AM by Eugene Berlin

    Wrong angles after changing the dimensions in parameter's sheet

    Eugene Berlin

      Good afternoon!

       

      I have very interesting problem by using SW 2016 SP0.

      I'm working on my master's thesis which goal is to parameterize the turbocompressor's stage.

       

      The problem is about 3D-sketch. At first I specify the angle between two lines (picture 1), and then, when I change its dimension in parameter's sheet, displayed angle have become wrong (picture 2). Points of lines belong to circles.

       

      Is it problem of SW or maybe I did something wrong?

      P.S.: angles have become correct, if changes are not very significant (less than 2 degrees).

       

       

      Thank you!

      Eugene