I attached a sheet metal part here which i did in solidworks 2009.It can be flat pattern but it is not as per the piece.Can any one help me to solve this ??
Sabareesh,,,, All of your bends are using a "bend allowance" of .45mm. That will not work. Especially for a 28mm bend radius. I suggest using a k-factor perhaps around .44 or the appropriate bend allowance or bend deduction for the corresponding bend radius and angles. Also would be a good idea to make your Cut Extrude1 a normal cut.
Heartful thanks Dennis.It works.Very helpful@
Retrieving data ...