AnsweredAssumed Answered

up to next Hole wont go through

Question asked by Ben Galili on Mar 23, 2016
Latest reply on Mar 23, 2016 by Kevin Pymm

hey there friends.

 

I have 2 weird problems....

1. When I choose up to  next as the end condition in a hole wizard thread, it wont go all the way through the material. (attached two pics)

2. when I do a 3D sketch, I cant see the coordinate system on the lower left side where it once was.

now when I think about it, its missing all the time... (attached PIC)

 

Regards

 

Ben

Outcomes