I was wondering if anyone can give me a hand adding the pockets that are highlighted in yellow in the drawing below. I attached my model (SW14) up to that point. I just cannot wrap my mind around how to do it. I was thinking of using the shell command but I don't think you can give different thicknesses for certain areas. If anyone can give step by step instructions on how to do it or upload a model so I can go thru the feature tree it would be greatly appreciated.

Thanks in advance,

Chris

I did an extrude, then a cut-loft, then a fillet, and a mirror to get this to work.

I made some ref planes, ref sketches, and assumptions to get the "right" geometry using the dimensions given.