AnsweredAssumed Answered

Trailing Zero on Dim

Question asked by Wayne Bird on Mar 18, 2016
Latest reply on Mar 21, 2016 by Kevin Chandler

I'm detailing a part that is toleranced and dual dimensioned.  I need the std dim to be four places and the metric dim to be 3 places.  The high limit dim is .1570 but the trailing zero is not being shown.  In the document settings I have trailing zeros to be shown.  In the model I have the dim set to 4 places and dual dimensioned and it shows correctly.  It's only in the drawing where the trailing zero is dropped.  Does anyone know what I'm doing wrong?

 

Also, on the same dimension I have a depth callout that doesn't need to be dual dimensioned at all.  Is there a way to only show the dual dimension on the hole callout, but not the depth callout?

 

2016-03-18_113251.jpg

Outcomes