14 Replies Latest reply on Mar 21, 2016 10:47 PM by Steven Fraser

    Extend Weldment to face

    Steven Fraser

      Hi guys,

      I'm designing a frame for one of our products at work. I know the basics of weldments and have made the model using it but I'm having some troubles with the trim/extend command.

       

      The image below points out the issues I'm having. On the left detail I want to extend the angle all the way to the end as show in green. On the right I want the angle to stop at the edge of the others, it is not trimming back the small radius inside shown in red.

       

      Trim-Extend Issue.jpg

      If you could help me out with this that would be greatly appreciated.

       

      Thanks