I have a property in configuration specific that is the value ofthickness. When I change the name of the configuration the value ofthe thickness it does not update. More precise the "@Default" doesnot update with the new name of the configuration. The otherproperties like surface area are updated.
There is any solutions for this issue? Or is a bug of the SWsoftware.
Nucu
I used a design table to control the features of this part. I think that is easier than using the Configuration Driven option for each dimension.Faur Arama wrote:
...When I change the name of the configuration the value of
the thickness it does not update...
Thank you for your answer. Yes the DT is a solution butwhen I have one configuration I must make a DT containing theseproperties. The problem is that the thickness I know it but thesurface area must be calculated. Normally I think that SW mustupdate these values each time I make changes in configurationname.
Does your thickness property exists in all your specific configurations?